1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.
Dismiss Notice
You must be a registered member in order to post messages and view/download attached files in this forum.
Click here to register.

Do all basic dim's need to be on layout report?

Discussion in 'GD&T Standards and Practices - ASME & ISO' started by Alan Ziehm, Feb 27, 2020.

  1. Alan Ziehm

    Alan Ziehm New Member

    Joined:
    Feb 27, 2020
    Messages:
    1
    Likes Received:
    0
    Trophy Points:
    1
    If a basic dimension on a drawing exists to control a profile should it be included on the layout report? If so, I assume it is reported as basic without a tolerance, correct? Thanks
     
    Alan Ziehm, Feb 27, 2020
    #1
  2. Miner

    Miner Moderator Staff Member

    Joined:
    Jul 30, 2015
    Messages:
    613
    Likes Received:
    532
    Trophy Points:
    92
    Location:
    Greater Milwaukee USA
    The actual requirement is the profile. The basic dimension exists only to provide the specifics of the profile. Record the profile as the requirement and document the results of the profile measurements.
     
    Miner, Feb 28, 2020
    #2
    Andy Nichols likes this.