1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.
Dismiss Notice
You must be a registered member in order to post messages and view/download attached files in this forum.
Click here to register.

Checking Aids

Discussion in 'Gage R&R and MSA - Measurement Systems Analysis' started by Larry Ricketts, Apr 5, 2016.

  1. Larry Ricketts

    Larry Ricketts Member

    Joined:
    Jan 8, 2016
    Messages:
    7
    Likes Received:
    0
    Trophy Points:
    1
    During a PPAP submission there is a requirement for Checking Aids. What needs to be supplied? Calibration records, layout of fixtures? Is a checking aid considered every gage used to create a part or is could it just be the final assembly gage that is used to check conformity.
     
    Larry Ricketts, Apr 5, 2016
    #1
  2. Reluctance

    Reluctance Member

    Joined:
    Aug 7, 2015
    Messages:
    10
    Likes Received:
    11
    Trophy Points:
    2
    Location:
    Iowa
    Yes, that.
     
    Reluctance, Apr 5, 2016
    #2