1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.
Dismiss Notice
You must be a registered member in order to post messages and view/download attached files in this forum.
Click here to register.

Search Results

Search Again
  1. shankar Jadhav
    Thread

    Subgroup in SPC

    What will effect of subgroup in SPC study.
    Thread by: shankar Jadhav, Nov 17, 2015, 4 replies, in forum: SPC - Statistical Process Control
  2. shankar Jadhav
    Thread

    What is UPR (Undulations Per Revolution) in Roundness

    Can anybody explain UPR (Undulation per revolution) in roundness and what standard exists for same.
    Thread by: shankar Jadhav, Oct 17, 2015, 3 replies, in forum: GD&T Standards and Practices - ASME & ISO
  3. shankar Jadhav
    Thread

    What is the impact if gages calibrated at 20° are used at 35°

    Why we do calibration in 20 ° and we are using gauges at temp about 30 to 35 °. what is the impact on gauge. please anyone explain.
    Thread by: shankar Jadhav, Oct 8, 2015, 7 replies, in forum: Gage Calibration and Uncertainty
  4. shankar Jadhav
    Post

    MSA reaction plan if a test fails

    Thanks. We done the MSA for family of gauges.in that case not possible to do the MSA of all instrument. then what is the selection...
    Post by: shankar Jadhav, Sep 16, 2015 in forum: Gage R&R and MSA - Measurement Systems Analysis
  5. shankar Jadhav
    Thread

    MSA reaction plan if a test fails

    What is my reaction plan if my GRR and bias,linearity and stability is not as per acceptance criteria. what action will taken on components?...
    Thread by: shankar Jadhav, Sep 15, 2015, 3 replies, in forum: Gage R&R and MSA - Measurement Systems Analysis
  6. shankar Jadhav
    Thread

    MSA: GRR Multiplication Factor of 5.15 Vs 6

    Historically, by convention, a 99% spread has been used to represent the “full” spread of measurement error, represented by a 5.15 multiplying...
    Thread by: shankar Jadhav, Sep 5, 2015, 2 replies, in forum: Gage R&R and MSA - Measurement Systems Analysis
Showing results 1 to 6 of 6
Search Again