Dismiss Notice
You must be a registered member in order to post messages and view/download attached files in this forum.
Click here to register.

AS9102 Lapse in production.

Discussion in 'AS 91XX - Aerospace Quality Standards' started by **Carl**, Sep 22, 2017.

Tags:
  1. **Carl**

    **Carl** New Member

    Joined:
    Sep 22, 2017
    Messages:
    1
    Likes Received:
    0
    Trophy Points:
    1
    Hello,

    I wondered if someone can shed some light on my first posting

    Does a partial FAI for 2 year laps in production require a full dimensional mark off (form 3) for re-validation of tooling or is this covered with a baseline part number from previous submission?

    Thanks
     
  2. D.Pat Foster

    D.Pat Foster New Member

    Joined:
    Apr 24, 2019
    Messages:
    1
    Likes Received:
    0
    Trophy Points:
    1
    I recently went thru this exact issue with a World Leading Aerospace Customer and after some tugging, they agreed that just the top header on pg 3 be completed and a statement anywhere below similar to " no change to fit,form or function since last production run" be added...and that's it. Hope it helps you.
     

Share This Page