1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.
Dismiss Notice
You must be a registered member in order to post messages and view/download attached files in this forum.
Click here to register.

Reporting Surface Profile All Around on the AS9102

Discussion in 'GD&T Standards and Practices - ASME & ISO' started by wilster98, Jun 25, 2019.

  1. wilster98

    wilster98 New Member

    Jun 25, 2019
    Likes Received:
    Trophy Points:
    As I understand it, when surface profile all around is called out on a drawing, the call out is ballooned and all of the measurements that make up the surface profile are reported as a range of the deviation. Most of our customers want it that way, but we occasionally get a customer that wants all features ballooned. What is the correct practice, and is there a spec to back it up, AS9102B does not address the issue.

    Thanks in advance