Thank you Emmyd for the calculator, at least now I understand the formula but I fear Miner is correct, I can't to a Cpk on position. I just hope...
Hello, Customer is looking for a cpk on a measurement for positional tolerance of a hole. The problem I have with this is the nominal...
Hello and thank you again for your replies, On cast materials is very hard for us to check how many hits a tap made because of the raw material....
Hello and thank you for your replies, I don't know if "lamination" is the correct word, on the microscope the sides of the threads look like...
Hello, I have some trouble with small lamination on a threaded hole of M8x1, after tapping the surface of the thread is very rough (caught on...
Separate names with a comma.