Jennifer, I have been reading you for over ten years. I hope you don't stop writing after retirement. In the end, I keep my integrity because I...
Nice rant, ncwalker! 3) They "put you in your place" emotionally - belittle you - then you find a different job. That's not a healthy place to...
Thank you VERY much!
That's what I would like to say to them......
Silly, yes. Serious, Yes. Even after 5 years, someone in management is questioning QA's need for 3x3x10 MSA to be done by the operators that run...
Thank you, that should help in our development!
Does anyone have a generic PFMEA (secondarily a C Plan) for a small machine shop that does 1 to 10 piece precision orders? Receive, Lathe side 1,...
Thanks! That helps a bit. We'll be ok.
PLEASE LOCATE ME IN PROPER THREAD. Need Work Instructions for Calibrations of Calipers, Micrometers, etc. We have an AS9100C Audit this...
We looked at simple and easy to use as criteria. GAGEpack is what we set up. I've been happy with it, it is easy to teach and explain. Many...
Hard to understand, but there is a push in a certain 150 emp company with ±2000 ring gages from 1/2 inch to 18" wants to "calibrate" our ring...
Thank you for the clarity without getting bogged down!
In all seriousness, which would be used if the gage is used for BOTH SPC and final part inspection?
I had always used a "saw tooth- staircase" run chart to monitor tool wear, bottom of spec to top of spec. The problem is explaining that to a...
Separate names with a comma.