1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.
Dismiss Notice
You must be a registered member in order to post messages and view/download attached files in this forum.
Click here to register.

Artifact kit to facilitate MSAs?

Discussion in 'Gage R&R and MSA - Measurement Systems Analysis' started by Richard Carruth, Jan 10, 2024.

  1. Richard Carruth

    Richard Carruth New Member

    Joined:
    Jan 10, 2024
    Messages:
    1
    Likes Received:
    0
    Trophy Points:
    1
    Would is be good to have an MSA kit created per say that has 10 master gages similar to circle, diamond, square artifacts that were the same physically, but the characteristic dimensions were all slightly different? This would establish 10 serialized artifacts that have NIST traceable master data that could be used to facilitate MSAs. The artifacts could have surface profile, true hole position, linear dimensions, steps and gaps, hole diameter, centricity etc. Would this be too much or is this worth pursuing?
     
    Richard Carruth, Jan 10, 2024
    #1
  2. Andy Nichols

    Andy Nichols Moderator Staff Member

    Joined:
    Jul 30, 2015
    Messages:
    5,110
    Likes Received:
    2,562
    Trophy Points:
    112
    Location:
    In the "Rust Belt"
    Richard, welcome:
    I’m tempted to suggest that if it was appropriate, someone would have produced them. If I understand correctly, part of the reason for the study is to evaluate the actual part features as produced, with their inherent issues, not using “lab samples”.
     
    Andy Nichols, Jan 12, 2024
    #2