1. 

   Rungrote Sa New Member

   Joined:

   Sep 23, 2022

   Messages:

   2

   Likes Received:

   0

   Trophy Points:

   1

   My job has used Pin Gauge to check Hole of parts as Go , NoGo only. Everytime before using , operator will check Pin diameter Top-Bottom X,Y. Judgement is that Go >= Minimum Spec , NoGo <= Maximum spec. and Record in Lot's datasheet. Pin gauge is not Calibrated. But Micrometer is Calibrated.
   
   Can This method be accepted IATF16949?

    

   Rungrote Sa, Sep 23, 2022

   #1
2. 

   Andy Nichols Moderator Staff Member

   Joined:

   Jul 30, 2015

   Messages:

   5,109

   Likes Received:

   2,562

   Trophy Points:

   112

   Location:

   In the "Rust Belt"

   You are permitted to use "verified" measuring devices as well as "calibrated" devices. Record the micrometer which is used to verify the pin gauge. I'm assuming the micrometer is the correct discrimination for the pin gauge size.

    

   Andy Nichols, Sep 23, 2022

   #2

   tony s and Rungrote Sa like this.

Your name or email address:

Do you already have an account?

• No, create an account now.
• Yes, my password is:
• Forgot your password?

Stay logged in